Analisa Optimasi Diameter Jaringan Pipa Distribusi Air Bersih Dengan Menggunakan Software EPANET, LINGO di Jalur Sentul City PDAM Tirta Kahuripan Kabupaten Bogor

Authors

DOI:

https://doi.org/10.21776/ub.rekayasasipil.2020.014.02.8

Keywords:

Pipe Size, Relative Energy, Pipe Networking, Linear Programming, Optimization

Abstract

One of the most important roles of water system supply is piping networking. Performance of water supply sistem service is determined not only by a capacity from the source, but also by water volume which must also be up to the vertices with high flow and adequate pressure as needed. Besides, the effectiveness of a pipline is measured from the cost of investment and operational cost over life of specified order. In order to achieve adequate pressure and flow conditions it must be analyzed the size carefully. Linear programming represents the completion of operations research techniques that can solve optimization problems. Linear prograsmming is used to minimize cost size of pipe. On this research, a sample informartion taken by a clean water distributin network in PDAM Tirta Khuripan, Bogor, West Java. By using the method of linear programing the result of optimization in PDAM Tirta Khuripan, Bogor, West Java diameter on each pipe  in with the selection of the main pipe diameter between 8 inch to 22 inch and pressure energy or relative energy is 2 metes into 7 metes by license set.

 


References

Sulianto, 2013, ‘’Linear Programming untuk pencarian Diameter Optimum Pada Jaringan Pipa Terbuka Dalam Sistem Penyediaan Air Bersih’’,Jurnal Penelitian Program PBP, UMM, Malang, Indonesia.

Kodoatie, Robert J.,2002, Hidrolika Terapan: Aliran pada saluran terbuka dan pipa, Terjemahan oleh sasongko, Erlangga, Jakarta.

Permana, Rega Putra, 2013. Optimasi Diameter Pipa Pada Sistem Jaringan Air Bersih Dengan Menggunakan Linear Proggramming Di Kecamatan Turen Malang. Skripsi Jurusan Teknik Sipil Universitas Muhamadiah Malang.

Noerbambang, M. Soufyan, Takeo Morimura. 2002. Perencanaan dan Pemeliharaan Sistem Plambing, PT.Pradnya Paramitha, Jakarta.

Ramana, Dr.G. Venkata, 2015. Network analysis of water distribution system in rural areas using EPANET, India.

Anisha.G, 2016. Analysis and Design of Water Distribution Network Using EPANET for Chirala Municipality in Prakasam District of Andhra Pradesh, International Journal, Cina.

Cisty. M dan Bajtek. Z (2008) optimal design of water distribution systems by a combination of stochastic algorithms and mathematical programming, Slovak University of Technology,Milan, Italia.

Ratnanik, Supratikno, 2019. Optimasi Distribusi Jaringan Air Bersih PDAM Klaten Wilayah Utara dengan Program Waternet, Universitas Widya Dharma, Klaten, Jawa Tengah.

Silvia Suciatina Cut, 2016. Kajian Tingkat Kehilangan Air Dengan Metode NRW Pada PDAM Tirta Meulaboh, Magister Teknik Sipil Program, Universitas Syiah Kuala Banda Aceh, Aceh.

Armanto Novan Ricki, 2016. Analisis dan Perencanaan Pengembangan Sistem Distribusi Air Minum di PDAM Unit Plosowahyu Kabupaten Lamongan, Institut Teknologi Sepuluh November, Surabaya, Jawa Timur.

Downloads

Published

2020-07-06

How to Cite

Nuryani, N., & Santosa, B. (2020). Analisa Optimasi Diameter Jaringan Pipa Distribusi Air Bersih Dengan Menggunakan Software EPANET, LINGO di Jalur Sentul City PDAM Tirta Kahuripan Kabupaten Bogor. Rekayasa Sipil, 14(2), pp.136 – 142. https://doi.org/10.21776/ub.rekayasasipil.2020.014.02.8

Issue

Section

Articles